Command/Response Table For Special Function Sis Commands - Extron electronics MLS 304MA User Manual

Extron medialink switchers user's manual
Hide thumbs Also See for MLS 304MA:
Table of Contents

Advertisement

Command/response table for special function SIS commands

The syntax for setting a special function is __ *
To view a function's setting, use __#, where __ is the function number. In the following table the values of
the
variable are different for each command/function. These values are given in the right column.
X?
Command
Delay times
Set the RGB delay
(Triple-Action Switching).
Example:
Audio settings
Set the preamp output mode.
N
If mono is selected, the audio signal is the same on both the left and right channels.
If stereo is selected, the switcher sends out different (stereo) signals on the left and right channels.
Set the loudness control.
Set line level audio outputs' levels
N
If the connector is wired for balanced output, the level is +6 dB higher than if it is wired for unbalanced output.
Mode selection
Select the Monitor Out output mode 28 * X? #
#, where __ is the function number and
X?
ASCII Command Response
(host to switcher)
(switcher to host)
3 * X? #
RGBDly*X? ]
3*7#
RGBDly*07]
18 * X? #
PreAmpMod* X? ]
29 * X? #
Loudness*X? ]
40 * X? #
LineLevel*X? ]
MonitorOutOpt*X? ]
MLS 304 Series, MLS 406Series • Serial Communication
is the value.
X?
values
X?
and additional descriptions
0 = 0.0 seconds (default), 1 = 0.5
seconds, 2 = 1.0 seconds,
... in ½ second steps up to
10 = 5.0 seconds
Example: 3.5 second RGB delay.
Set the line level audio
(Lineout's and Preamp's)
outputs to be either mono or
stereo signals.
1 = mono
2 = stereo (default)
When output volume is low,
provide a +6 dB boost at 100Hz
and at 10 kHz. When output
volume is high, decrease the
boost at those frequencies.
This improves sound richness
by restoring the high and low
frequencies to which the ear is
insensitive to at low volume
levels. The effect diminishes as
volume is increased.
0 = off (default for firmware ver.
2.1 and higher) (remove boost)
1 = on (default for firmware ver.
2.0 and lower) (turn boost on)
1 = -10 dBV (-8 dBu, 0.32 Vrms),
unbalanced output (default)
2 = +4 dBu (+6 dBV, 1.23 Vrms),
balanced output
See pages 3-7 and 3-8 for an
explanation of these modes.
1 = mode 1 (RGB follow mode)
2 = mode 2 (DA mode)
3 = mode 3 (standard mode)
4-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mls 304saMls 406Mls 406maMls 406sa

Table of Contents