Appendix I - Specifications - Pride Mobility Quantum series Owner's Manual

A P P E N D I X I – S P E C I F I C A T I O N S
Suspension:
Drive Wheels:
Caster Wheels:
Anti-tip Wheels:
1
Maximum Speed:
1,4
Range:
Brakes:
2
Ground Clearance:
2
Turning Radius:
2
Overall Size:
Drivetrain:
3
Batteries:
Battery Charger:
Weight Capacity:
5
Component Weights:
1
Varies with base model, user weight, terrain type, battery amp hour rating (Ah), battery charge, battery condition, motors,
controller type, tire type, and tire condition. This specification can be subject to a variance of (+ or -) 10%.
2
Due to manufacturing tolerances and continued product improvement, this specification can be subject to variance of
(+ or -) 3%.
3
AGM or Gel-Cell type required. See VI. "Batteries and Charging."
4
Tested in accordance with ANSI/RESNA WC Vol 2, Section 4 and ISO 7176-4 Standards. Results derived from
theoretical calculation based on the battery specifications and drive system performance. Test conducted at maximum
weight capacity.
5
Battery weight may vary based on manufacturer.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176 EN12184
standards. All specifications subject to change without notice.
Quantum 1121 Series
SPECIFICATIONS
Active-Trac
14 in. (35.56 cm), pneumatic or solid, center-mounted
8 in. (20.32 cm), solid, rear articulating
6 in. (15.24 cm), solid, front mounted
Up to 5 mph (8.05 km/h)
Variable up to 15 miles (24 km)
"Intelligent Braking" electronic regenerative, disc park brake
See figure 26.
See figure 26.
Length: See figure 26.
Width: See figure 26.
Two motor, mid-wheel
Two 12-volt, deep-cycle NF-22 batteries
8-amp off-board
300 lbs. (136 kg)
75 lbs. (34.02 kg) with Synergy Manual Tilt
Base: 140 lbs. (63.5 kg)
Batteries: 38 lbs. (17.23 kg) each
www.pridemobility.com 35