Pride Mobility QUANTUM JAZZY Series Owner's Manual page 29

V . C O M F O R T A D J U S T M E N T S
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating seat,
you can change the seat height either through the controller
or through a toggle switch mounted to one of the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat. See
figure 22.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run
more than a few seconds after the mecha-
nism reaches the top or bottom limit.
NOTE: For more information on operating the power ele-
vating seat through the controller, contact your Quantum
Rehab Provider.
WARNING!
option is intended for use on a level surface
only. Never raise the seat from its lowest
position on an inclined surface. Failure to
heed this warning can result in the power
chair tipping over.
WARNING!
lowest position when operating your power
chair on bumpy or uneven surfaces. Failure
to heed this warning can result in the
power chair tipping over.
WARNING! Never raise the power elevating
seat while your power chair is in the free-
wheel mode.
WARNING! Always fasten the positioning
belt when operating the power elevating
seat.
NOTE: The power elevating seat option is equipped with
a system that reduces the speed of the power chair by one
half when the seat is elevated more than 2.5-5 in. (1–2
cm.). Always check to be sure this system is operating
properly before using your power chair.
Quantum Jazzy 1420 Series
The power elevating seat
Never raise the seat from its
www.pridemobility.com
Figure 22. Power Seat Toggle Switch (Shown on
Armrest)
29