Installation; Mst-431 Installation; Power Via Power Over Ethernet; Msd-431-L Installation - AMX MST-431 Instruction Manual

Installation

MST-431 Installation

Any USB peripherals (mouse, keyboard, etc.) may be connected to the USB port on the rear of the device (FIG. 5).
Updates to the device's firmware are also made via the USB port.
FIG. 5 Connectors on the rear of the MST-431

Power via Power Over Ethernet

Power for the MST-431 is supplied via Power Over Ethernet (PoE), utilizing an AMX-certified, capacitive touch-
compliant PoE injector such as the PS-POE-AT-TC High Power PoE Injector (FG423-83) or other approved AMX PoE
power source. The incoming Ethernet cable should be connected to the RJ45 port on the device (FIG. 5).

MSD-431-L Installation

The MSD-431-L may be installed directly into a solid surface environment, using either solid surface screws or the
included locking tabs for different mounting options. Once installed, the MSD-431-L is contained within a clear outer
housing known as the back box (FIG. 6). This back box is removed when installing the device into a wall or into a
Rough-In Box.
FIG. 6 MSD-431-L Back Box

Installing the MSD-431-L into a wall

The MSD-431-L comes with a clear plastic backbox (designed to attach the panel to most standard wall materials. This
backbox has four locking tabs (two on top and two on bottom) to help lock the backbox to the wall. These locking tabs
are only extended AFTER the backbox is inserted into the wall. (FIG. 7 and FIG. 8).
When installing the backbox, make sure that the assembly is in the correct position
and in the correct place. Once the locking tabs are extended and locked into place,
removing the backbox may be difficult without having access to the back of the wall
or causing damage to the wall.
MST-431/MSD-431-L 4.3" Modero S Series® Touch Panels
USB Port RJ-45 Port Speaker
Locking tabs
Installation
9