How To Remove The Optical Block Assembly - JVC GY-HD100E Service Manual

Fig. 1.1.2 (2)
(2) Disconnect the cables CN14, CN24 and CN43 on AUDIO
board, CN10 and CN52 on STA board, CN52 on SWP board.
CN52 CN10 CN43 CN24 CN14
Fig. 1.1.2 (3)
1-2
1.2

HOW TO REMOVE THE OPTICAL BLOCK ASSEMBLY

CAUTION
When removing/mounting the optical block assembly in the
camera, take care not to damage cables, also the position-
ing of the wire assembly is important. A malfunction may
occur if a wire is somehow caught up.
4
(1) Remove left side cover and the right side cover. (see sec-
tion 1.1.1 and 1.1.2)
(2) Remove the two screws
(3) Remove the two screws
(4) Disconnect the cables CN26, CN27 and CN28.
1
and remove the FAN motor.
1
Fig. 1.2 (1)
2
and remove the SD board.
2
CN26 CN27
CN28
Fig. 1.2 (2)