HP PAVILION DV2700 Maintenance And Service Manual page 115

When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
RTC battery (see RTC battery on page
●
Memory modules (see
●
WLAN module (see
●
● Modem module (see
Remove the system board:
Disconnect the power connector cable (1) from the system board.
1.
Remove the two Phillips PM2.5×5.0 screws (2) that secure the system board to the computer.
2.
Use the optical drive connector (1) to lift the right side of the system board until it rests at an angle.
3.
Release the system board (2) by sliding it to the right at an angle until the connectors on the left side
4.
of the system board disengage from the base enclosure.
Remove the system board (3).
5.
70)
Memory module on page
WLAN module on page
Modem module on page
71)
65)
95)
Component replacement procedures 107