Chapter 3. Quick Installation Guide; Tcp/Ip Configuration - TP-Link TL-WR940N User Manual

Chapter 3. Quick Installation Guide

This chapter will show you how to configure the basic functions of your TL-WR941ND 300Mbps
Wireless N Router using Quick Setup Wizard within minutes.
3.1

TCP/IP Configuration

The default domain
http://tplinklogin.net, the default IP address is 192.168.0.1, and the default Subnet Mask is
255.255.255.0. These values can be changed as you desire. In this guide, we use all the default
values for description.
Connect the local PC to the LAN ports of the router. And then you can configure the IP address for
your PC in the following two ways.
Configure the IP address manually
1) Set up the TCP/IP Protocol for your PC. If you need instructions as to how to do this,
please refer to
2) Configure the network parameters. The IP address is 192.168.0.xxx ("xxx" is any number
from 2 to 254), Subnet Mask is 255.255.255.0, and Gateway is 192.168.0.1 (The router's
default IP address)
Obtain an IP address automatically
1) Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC.
If you need instructions as to how to do this, please refer to
PC."
2) Then the built-in DHCP server will assign IP address for the PC.
Now, you can run the Ping command in the command prompt to verify the network connection
between your PC and the router. The following example is in Windows XP.
Open a command prompt, and type ping 192.168.0.1, and then press Enter.
If the result displayed is similar to the Figure 3-1, it means the connection between your PC
and the router has been established well.
TL-WR940N/TL-WR941ND
name of the TL-WR941ND
Appendix B: "Configuring the PC."
300Mbps Wireless N Router
300Mbps
Appendix B: "Configuring the
-8-
Wireless N Router is