Cisco Catalyst 4500 Series Message Manual page 66

IOSINTF Messages
Error Message C4K_IOSINTF-5-GBICREMOVED: Slot= [dec] Port= [dec]: GBIC has been
removed
Explanation
Recommended Action
Error Message C4K_IOSINTF-5-NOPRIMARYVLANASSOCIATION:Packet received on interface
[char] in vlan [dec]
secured.
Explanation
VLAN association. The switch will not secure a MAC address in this situation.
Recommended Action
Error Message C4K_IOSINTF-5-NOTXVLAN:Router Port [char] has no internal vlan
assigned to transmit packet
Explanation
duplicate IP network assignments exist on different Layer 3 interfaces.
Recommended Action
correct IP network, and enter the no shutdown command on this interface.
Error Message C4K_IOSINTF-5-NOTXVLAN:Router Port [char] has no internal vlan
assigned to transmit packet
Explanation
after the module in that slot was removed. Because the module no longer exists, the packets are
dropped.
Recommended Action
technical support representative.
Error Message C4K_IOSINTF-5-OUTPACLDISABLEDUETORACL: Output PACL [char] is disabled
on port [char]
Explanation
port is disabled. Output RACL and output PACL are mutually exclusive, it is not possible to
configure both simultaneously.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-46
An approved-vendor GBIC or SFP was removed.
This is an informational message only. No action is required.
without primary vlan association. [mac-addr] will not be
The switch received a packet on a secondary VLAN which does not have a primary
Associate this secondary VLAN with a valid primary VLAN.
The specified Layer 3 interface does not have an assigned internal VLAN because
Remove the duplicate IP network that is configured on the interface. Assign the
Occasionally during hot-swapping operations a previously queued packet is transmitted
If the problem persists even without any hot-swapping operations, contact your
If the port is configured for an SVI that has output RACL, then the output PACL on the
This is an informational message only. No action is required.
Chapter 2 Messages and Recovery Procedures
OL-11541-01