Cisco Catalyst 4500 Series Message Manual page 52

EC Messages
Error Message EC-5-ERRPROT: Channel protocol mismatch for interface [char] in group
[dec]: the interface can not be added to the channel group
Explanation
Recommended Action
Error Message EC-5-ERRPROT2: Command rejected: the interface [char] is already part
of a channel with a different type of protocol enabled
Explanation
a channel with a different type of protocol enabled.
Recommended Action
Error Message EC-5-ERRPROT3: Command rejected: the interface [char] is already part
of a channel
Explanation
of a channel.
Recommended Action
Error Message EC-5-L3DONTBNDL1:[char] suspended: PAgP not enabled on the remote
port.
Explanation
enabled. In this mode, the port is put in a suspended state.
Recommended Action
Error Message EC-5-L3DONTBNDL2: [char] suspended: LACP currently not enabled on the
remote port.
Explanation
enabled. In this mode, the port is put in a suspended state.
Recommended Action
Error Message EC-5-NOLACP: Invalid EC mode
Explanation
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-32
The interface cannot be added to the channel group with the specified mode.
Change the channel group or the mode for the interface.
The interface cannot be selected for the specified protocol because it is already part of
Remove the interface from the channel group.
The interface cannot be unselected for the specified protocol because it is already part
Remove the interface from the channel group.
PAgP is enabled on the Layer 3 interface, but the partner port does not have PAgP
Enable PAgP on the remote side.
LACP is enabled on a Layer 3 interface, but the partner port does not have LACP
Enable LACP on the remote side.
LACP is not included in the image. You cannot set EC mode to active or passive.
Upgrade to an image with LACP, or set the mode to On.
Chapter 2 Messages and Recovery Procedures
OL-11541-01