Switchingengineman-4 - Cisco Catalyst 4500 Series Message Manual

SWITCHINGENGINEMAN Messages
Error Message C4K_SWITCHINGENGINEMAN-3-TXCNTMEMORYPARITYERROR: Parity error in
transmit count memory, addr=[hex], reg bits=[hex], total errors=%u
Error Message C4K_SWITCHINGENGINEMAN-3-QUEUEMEMORYPARITYERROR:Parity error in Queue
Memory, addr=[hex], total errors=%u
Error Message C4K_SWITCHINGENGINEMAN-3-TRANSMITQUEUESINIT:Tx Queues initialized
multiple [dec] times
Error Message C4K_SWITCHINGENGINEMAN-3-RXDELIMITERERROR: Invalid packet delimiter
received. Expected [hex] Received [hex]

SWITCHINGENGINEMAN-4

Error Message C4K_SWITCHINGENGINEMAN-4-PACKETMEMORYERROR: Error in Packet Memory
[dec]
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-114
An error in transmit count memory was detected.If this message persists, it may indicate
Explanation
a transient hardware problem, or a more permanent problem. After 128 such transmit count errors,
the switch will reload.
If the switch is reloading too often due to this condition, you may need to check
Recommended Action
for environmental conditions such as RFI or other interference. It may also be necessary to replace
the supervisor engine.
There is a parity error in the queue memory. This condition might indicate a transient
Explanation
hardware problem or a more permanent problem. After 128 packet memory and queue memory
errors, the switch reloads.
If this message reoccurs, reboot the switch.
Recommended Action
The transmit queues had to be initialized multiple times.
Explanation
This is an informational message only. No action is required.
Recommended Action
Successive packets that are sent by the hardware to the CPU have a specific delimiter
Explanation
pattern. The software expected a delimiter pattern but received some other pattern. This condition
might be caused by synchronization loss between the hardware and the software.
Reboot the switch.
Recommended Action
An error in packet memory was detected. If this message persists, it might indicate a
Explanation
hardware problem.
If this message persists, use the show diagnostics online command, contact
Recommended Action
your technical support representative, and provide the representative with the gathered information.
Chapter 2 Messages and Recovery Procedures
OL-11541-01