Idbman-6; Ilcprotocolerror Messages; Iosaclman Messages - Cisco Catalyst 4500 Series Message Manual

ILCPROTOCOLERROR Messages

IDBMAN-6

Error Message IDBMAN-6-VLANMAPPED:Vlan [dec] is mapped to [char]
ILCPROTOCOLERROR Messages
This section contains the ILC Protocol (ILCPROTOCOLERROR
Error Message C4K_ILC-3-PROTOCOLERROR: Service Module failed S2W protocol, error
[dec], state [dec]

IOSACLMAN Messages

This section contains the Catalyst 4500 series Cisco IOS ACL management (IOSACLMAN) messages.
Error Message C4K_IOSACLMAN-4-ACLTYPEMISMATCH: Acl RkiosSharedIos[char] was earlier
attached as [char] Acl. Please unconfigure all its uses before using it as a [char]
Acl
Error Message C4K_IOSACLMAN-4-MOLACLALLOCFAILURE: Mol Acl Allocation for [char] is
failed
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-42
The given VLAN was mapped to the specified interface.
Explanation
This is an informational message only. No action is required.
Recommended Action
The Serial 2-Wire (S2W) communication with an intelligent line card deviated from the
Explanation
defined protocol.
This is an informational message only. No action is required.
Recommended Action
This message displays if you attach a named ACL as one type, delete the ACL, and
Explanation
configure an ACL of a different type with the same name. For example, you configure a named IP
ACL using the name DefaultAcl, attach it to a router port, and then delete the ACL DefaultAcl by
entering no ip access-list extended DefaultAcl. You could configure a MAC ACL using the same
name. This message is displayed when you try to configure any ACEs in the MAC ACL.
Recommended Action Remove all configurations where the ACL is used as an IP ACL before
configuring a MAC ACL with the same name.
Explanation A new MOL ACL was created but there was insufficient memory for a MOL ACL. The
ACL was not applied.
Remove all configurations where the ACL is used as an IP ACL before
Recommended Action
configuring a MAC ACL with the same name.
Chapter 2 Messages and Recovery Procedures
message.
)
OL-11541-01