Applicable Standards And Reference Documentation; Standards; Applicable Reference Documents - Seagate ST32430W Product Manual

2
_____________________________________________________________________________________
2.0

Applicable standards and reference documentation

The drive has been developed as a system peripheral to the highest standards of design and construction. The
drive depends upon its host equipment to provide adequate power and environment in order to achieve
optimum performance and compliance with applicable industry and governmental regulations. Special
attention must be given in the areas of safety, power distribution, shielding, audible noise control, and
temperature regulation. In particular, the drive must be securely mounted in order to guarantee the specified
performance characteristics.
2.1

Standards

The Hawk 2LP Family (Wide) complies with Seagate standards as noted in the appropriate sections of this
Manual and the Seagate SCSI Interface Manual, P/N 77738479 (Volume 2, Version 2).
The Hawk 2LP Family (Wide) is a UL Recognized component per UL 1950 and a CSA Certified component
per CAN/CSA-C22.2 No. 950-M89. It also meets the requirements of DIN VDE 0805:1993 and EN60950: 1992
(IEC 950).
The drive, as delivered, is designed for system integration and installation into a suitable enclosure prior to use.
As such the drive is supplied as a subassembly and is not subject to Subpart J of Part 15 of the FCC Rules
and Regulations nor the Radio Interference Regulations of the Canadian Department of Communications.
However, the unit has been tested using proper shielding and grounding and found to be compliant with Class
A limits of the FCC Rules and the Regulations of The Canadian Department of Communications.
The physical design characteristics of the drive serve to minimize radiation when installed in an enclosure that
provides reasonable shielding. As such, the drive is capable of meeting the Class B limits of the FCC Rules
and Regulations of the Canadian Department of Communication. However, it is the users responsibility to
assure that the drive meets the appropriate EMI requirements in their system. Shielded I/O cables may be
required if the enclosure does not provide adequate shielding. If the I/O cables are external to the enclosure,
shielded cables should be used, with the shields grounded to the enclosure and to the host controller.
2.2

Applicable reference documents

Installation Guide
SCSI Interface Manual
ANSI Small Computer System Interface (SCSI): Document Number ANSI3.131-1986 (X3T9/84.40 Rev. 1B)
(X3T9.2/82-2 Rev. 17B), X3T9.2/86-109 Revision 10H (SCSI-2) and X3T9.2-184 Rev. 4 (SCSI-3).
Package Test Specification Seagate P/N 30190-001 (under 100 lb.)
Package Test Specification Seagate P/N 30191-001 (over 100 lb.)
In case of conflict between this document and any referenced document, this document takes precedence.
Product Manual - Hawk 2LP Family (Wide) SCSI-2 (Volume 1), Rev. A
Seagate P/N 77767478
Seagate P/N 77738479