Power Sequencing; Current Profile; Figure 7.2.2-1 Typical Hawk 2Lp Family (Wide) Drive +5 V And +12 V Current Profile - Seagate ST32430W Product Manual

Product Manual - Hawk 2LP Family (Wide) SCSI-2 (Volume 1), Rev. A
_____________________________________________________________________________________
7.2.2

Power sequencing

The drive does not require power sequencing. The drive protects against inadvertent writing during power up
and down. Daisy-chain operation requires that power be maintained on the terminated drive to ensure proper
termination of the peripheral I/O cables. For the benefit of the system power supply, drive power up can be
delayed using the motor start delay option. See Section 10.1.
7.2.3 12 V - current profile
Figure 7.2.2-1 identifies the drive +5 V and +12 V current profile. The current during the various times is as
shown:
T -Power is applied to the drive.
T1 -Controller self tests are performed.
T2 -Spindle begins to accelerate under current limiting after performing drive internal diagnostics. See Note
1 of Table 7.2-1.
T3 -The spindle is up to speed and the Head-Arm restraint is unlocked.
T4 -The heads move from the landing zone to the data area.
T5 -The adaptive calibration sequence is performed.
T6 -Calibration is complete and the drive is ready for reading and writing.
Note. All times and currents are typical. See Table 7.2-1 for maximum current
requirements.
2.5
2.0
1.5
12V
Current
(amps)
1.0
0.5
0.8
0.6
5V
Current
(amps)
0.4
0.2
Figure 7.2.2-1. Typical Hawk 2LP family (Wide) drive +5 V and +12 V current profile
T1
T
0 2 4 6
0 2 4 6
T3 T4
T2
8 10 12 14
Seconds
8 10 12 14
Seconds
T5 T6
16 18 20
16 18 20
19