Table of Contents
Advertisement
Backplane Preparation
The chassis is shipped from the factory with the backplane fully equipped
with sockets (VME64X bus connectors), power connectors, and bus
terminator resistor networks. No special preparation or preassembly is
required prior to use.
You must configure the VME64X bus daisy-chain jumpers on the rear
(wire side) of the backplane. Refer to VITA 1.x Live Insertion for VME64x
requirements standard for more electrical detail and information on daisy-
chain jumpering.
Note
http://www.mcg.mot.com/literature
Backplane daisy-chain jumpers normally are shipped with
the chassis. If necessary, additional jumpers can be ordered
from Motorola.
Backplane Preparation
4-3
4
Advertisement
Table of Contents
