Hard drive
Description
Hard drive only (does not include bracket, cover, or screws):
500-GB, 7200-rpm, 7.0-mm
320-GB, 7200-rpm, 7.0-mm
320-GB, 5400-rpm, 7.0-mm
250-GB, 7200-rpm, 7.0-mm
250-GB, 5400-rpm, 7.0-mm
160-GB, 7200-rpm, 7.0-mm
Hard Drive Hardware Kit (includes bracket, cover, and screws)
Hard Drive Cable Kit (includes hard drive connector cable)
Before removing the hard drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the following components:
a.
Battery (see
b.
Service access cover (see
Remove the hard drive:
1.
Lift the shield (1) that covers the hard drive connector on the system board.
2.
Disconnect the hard drive connector cable (2) from the system board.
3.
Remove the three Phillips 2.0×4.0 screws (3) that secure the hard drive to the computer.
4.
Lift the shield (4) that covers the hard drive to allow removal of the drive.
Battery on page
40).
Service access cover on page
43).
Component replacement procedures
Spare part number
634925-001
649906-001 and
648925-001
648924-001
649902-001 and
648911-001
648910-001
649901-001
656272-001
628532-001
45