Usb Board And Internal Display Switch - HP Compaq Mini 700 Maintenance And Service Manual

USB board and internal display switch

NOTE: The internal display switch module is included in the Cable Kit, spare part number 507708-001.
Description
USB board
Before removing the USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Keyboard (see
b. Hard drive (see
c. Top cover (see
d. Fan (see
Remove the USB board:
1. Disconnect the internal display switch cable (1) from the USB board.
2. Remove the Phillips PM2.0×3.0 screw (2) that secures the DC jack bracket to the base enclosure.
3. Remove the DC jack bracket (1) and USB board (2) from the base enclosure.
Battery on page
Keyboard on page
Mass storage devices on page
Top cover on page
Fan on page 59).
37).
40).
42).
45).
Component replacement procedures
Spare part number
506336-001
61