HP Compaq Mini 700 Maintenance And Service Manual page 51

6. Lift the hard drive (4) up and slide it out of the drive bay.
Reverse this procedure to install the hard drive.
To remove the solid-state drive:
1. Release the ZIF connector (1) to which the SIM card cable is attached. The end of the cable lies
across the top of the solid-state drive.
2. Disconnect the SIM card cable (2), and then detach the tape from the top of the solid-state drive.
3. Release the LIF connector (1) to which the solid-state drive cable is attached.
4. Disconnect the solid-state drive cable (2).
5. Remove the two Phillips PM2.0×4.5 screws (3) that secure the drive bracket to the device.
Component replacement procedures 43