Cub Cadet 19A40002100 Operator's Manual page 10

Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute support in place by first
clipping the side portion onto the bagger support rail (1)
with the edge of the snap feature aligned with the red line,
as seen in the inset of Fig. 4-8.
2. Snap the front side of the chute support to the rail (2), as
shown in Fig. 4-8.
3. Install the bagger screen into the bagger cover by first
inserting the end closest to the center into the cutout
mounting hole, as in Fig. 4-9. Make sure to feed the screen
under the lip, as in Fig. 4-10.
4. Clip in the other side by flexing the screen and pushing it
down into the provided cutout hole. See Fig. 4-10.
10 s 4 — a
ectiOn sseMbly
2
Figure 4-8
Figure 4-9
& i
nstallatiOn
1
Make sure screen sits under the cover's lip
5. Install the bagger cover onto the bag support assembly, as
seen in Fig. 4-11. The plastic cover goes inside of the two
mounting tabs.
Cover mounts in
between these
two tabs
Figure 4-10
Figure 4-11