Central Pneumatic 97525 Assembly And Operating Instructions Manual page 4

heating up. Otherwise, the extension cord could melt and catch fire, or cause electrical
damage to the tool. Check your air compressor's manual for the appropriate size cord.
It is also possible that the use of an extension cord may cause your circuit breaker to
trip or your panel fuse to break. If this happens, either use the compressor without an
extension cord or find a larger amperage circuit to use.
19. Maintenance . The maintenance outlined in the maintenance section should be
performed regularly. For your safety, this product should be serviced or repaired
regularly only by a qualified technician.
20. Compressed air only
21. Do not load nails with the trigger or safety depressed. Unintentional
firing may occur. Do not load nails when the air hose is connected to the
tool. Always assume that the tool contains fasteners.
22. Disconnect air supply before loading Nailer
adjustments to) the Nailer make sure that the compressed air is disconnected.
23. Fire fasteners into an appropriate work surface only
fasteners into surfaces too hard to penetrate. Do not drive fasteners on top of other
fasteners, or at too steep of an angle. Fasteners can ricochet causing personal injury.
Never fire the Nailer into the air, or point it toward yourself or another person. Always
wear ANSI approved safety goggles during use, maintenance, and reloading.
24. Do not fire fasteners too close to the edge of a workpiece
workpiece and fly free, causing personal injury.
25. Take caution as some woods contain preservatives such as copper chromium
arsenate (CCA) which can be toxic. When stapling or nailing these materials extra
care should be taken to avoid inhalation and minimize skin contact.
26. Some dust created by power sanding, sawing, grinding, drilling, and other construction
activities, contain chemicals known [to the State of California] to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement or other masonry products
• Arsenic and chromium from chemically treated lumber
(California Health & Safety Code § 25249.5, et seq. )
27. Stay within air pressure capacity
28. Hold tool away from head and body
causing injury.
29. Transport Nailer safely
workplace. Carry the tool by the handle and avoid contact with the trigger.
30. The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
SKU 97525 For technical questions, please call 1-800-444-3353.
40115
. Never use combustible gas as a power source.
. Never operate the Nailer above 100 PSI.
. During operation the Nailer may kick back
. Always disconnect air supply when moving the tool in the
. Before reloading (or making any
. Do not attempt to fire
. They may split the
Page 4