Print Timeout - IBM Infoprint 1125 User Reference

Power Saver
Purpose:
To specify the amount of time (in minutes) the printer waits after a job is printed before it goes into a
reduced power state.
Values:
1...240 (60*)
Power Saver replaces the Ready message. When the printer is in Power Saver mode, it is still ready
to receive print jobs.
Select 1 to put the printer in Power Saver mode one minute after it finishes a print job. This uses much
less energy, but requires more warm-up time for the printer. Select 1 if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer
ready to print with minimum warm-up time. Select a value between 1 and 240 minutes if you want a
balance between energy consumption and a shorter warm-up period.

Print Timeout

Purpose:
To specify the amount of time (in seconds) the printer waits before printing the last page of a print job
that does not end with a command to print the page. The print timeout counter does not start until
Waiting is displayed.
Values:
Disabled
1...225 (90*)
See also:
Print Buffer
Argecy Computer Corporation 248-324-1800
Specifies the amount of time after a print job before the printer goes into Power Saver
mode.
The printer does not print the last page of a print job until one of the following occurs:
• The printer receives enough information to fill the page.
• The printer receives a Form Feed command.
• You select Print Buffer from the Job Menu.
The printer prints the last page after the specified time.
167