Installation; Preparations; Installing Vip X1600 Modules - Bosch VIP X1600 Installation And Operating Manual

VIP X1600
4

Installation

4.1

Preparations

The VIP X1600 modules are solely intended for installation in the VIP X1600 base. Installing
the units is a quick and easy operation that does not require any additional tools.
The VIP X1600 is designed for installation in a switch cabinet. Mounting the unit in a 19-inch
rack using the installation material supplied is a quick and easy operation.
It is also possible to operate this as a desktop unit. The four elastic bumpers included in the
scope of delivery ensure a non-slip support.
CAUTION!
The unit is designed for indoor operation.
Select a suitable location for installation that guarantees to meet the environmental
!
conditions. The ambient temperature must be between 0 and +50 °C (+32 and +122 °F). The
relative humidity must be between 20% and 80% (non-condensing).
The VIP X1600 generates heat during operation. During installation, please note the maximum
heat value of 205 BTU/h. Ensure that there is adequate ventilation and enough clearance
between the unit and heat-sensitive objects or equipment.
Please ensure the following installation conditions:
–
–
–
–
–
–
4.2

Installing VIP X1600 Modules

Installing the different VIP X1600 modules in the VIP X1600 base is described in the relevant
Quick Installation Guide. Please also take note of the following basic notes when installing a
unit.
CAUTION!
Do not install a VIP X1600 module in a different housing and do not operate the unit outside of
!
the VIP X1600 base. The ambient temperature during installation must be between
0 and +50 °C (+32 and +122 °F), and the relative humidity must not exceed 80% (non-
condensing).
Bosch Security Systems
Do not install the unit close to heaters or other heat sources. Avoid locations exposed to
direct sunlight.
Allow sufficient space for running cables.
Ensure that the unit has adequate ventilation. Bear the total heat output in mind,
particularly when installing multiple units in a switch cabinet.
When making connections, use only the cables supplied or use appropriate cables
immune to electromagnetic interference.
Position and run all cables so that they are protected from damage, and provide
adequate cable strain relief where needed.
Avoid impacts, blows and severe vibrations as these can irreparably damage the unit.
Installation and Operating Manual
Installation | en 17
V3.5 | 2007.12