Powering On The Technicolor Gateway - Technicolor TG587n v3 Setup And User Manual

3 MANUAL INSTALLATION

3.2 Powering on the Technicolor Gateway

Procedure
Proceed as follows:
1 Connect the power cord to the power port of the Technicolor Gateway.
2 Plug the other end of the power cord into an electrical outlet.
3 The Technicolor Gateway automatically starts up.
For more information about how to powering on/off the Technicolor Gateway, see
4 Wait at least two minutes to allow the Technicolor Gateway to complete the start up phase.
22
"Power switch" on page 7.
DMS-CTC-20101206-0017 v1.0