Ptz Control And Color Setup; Cable Connection; Ptz Setup - Jaycar Electronics N56 Series User Manual

Standalone dvr

Table of Contents

Click backup button, system begins burning. At the same time, the backup button becomes

stop button. You can view the remaining time and process bar at the left bottom.

File format: Click the file format; you can see there are two options: DAV/ASF.

Picture backup: Please set the corresponding time, channel and then select the type as

PIC from the dropdown list. See Figure 4-33. Please click the Add button and then select

the pictures. Click the Start button; you can copy the specified pictures to the selected

portable devices.

One key backup: It includes three steps: the search, select all, start the backup. You can

skip the above three steps and then copy all the searched files directly.

The file name format usually is: SN_CH+channel number+time Y+M+D+H+M+S. In the file

name, the YDM format is the same as you set in general interface. (Main Menu ->Setting -

>General).File extension name is .dav.

Tips:

During backup process, you can click ESC to exit current interface for other operation. The

system will not terminate backup process.

Note:

When you click stop button during the burning process, the stop function becomes activated

immediately. For example, if there are ten files, when you click stop system just backup five

files, system only save the previous 5 files in the device (But you can view ten file names).

4.8 PTZ Control and Color Setup

Note: All the operations here are based on PELCOD protocol. For other protocols, there

might be a little difference.

Please follow the procedures below to go on cable connection

Connect the dome RS485 port to DVR 485 port.

Connect dome video output cable to DVR video input port.

Connect power adapter to the dome.

Note: The camera video should be in the current screen. Before setup, please check the

following connections are right:

PTZ and decoder connection is right. Decoder address setup is right.

Decoder A (B) line connects with DVR A (B) line.

Boot up the DVR, input user name and password.

In the main menu, click setting, and then click Pan/Tilt Control button. The interface is shown

as in Figure 4-34. Here you can set the following items:

Figure 4-33

Table of Contents