Installation And Connections; Check Unpacked Dvr; About Front Panel And Rear Panel; Hdd Installation - Jaycar Electronics N56 Series User Manual

Standalone dvr

Table of Contents

3 Installation and Connections

Note: All the installation and operations here should conform to your local

electric safety rules.

When you receive the DVR from the forwarding agent, please check whether there is any visible

damage. The protective materials used for the package of the DVR can protect most accidental

clashes during transportation. Then you can open the box to check the accessories.

Please check the items in accordance with the list on the warranty card (Remote control is

optional). Finally you can remove the protective film of the DVR.

Note

Remote control is not a standard accessory and it is not included in the accessory bag.

The model label in the front panel is very important; please check according to your purchase

order.

The label in the rear panel is very important too. Usually we need you to represent the serial

number when we provide the service after sales.

You can refer to the Appendix for recommended HDD brand. Usually we do not recommend the

PC HDD. Please use HDD of 7200rpm or higher.

Please follow the instructions below to install hard disk.

This series DVR has one SATA HDD.

1. Loosen the screws of the

upper cover and side panel.

4. Turn the device upside down

and then turn the screws in

firmly.

2. Fix four screws in the HDD

(Turn just three rounds).

Fix the HDD firmly.

3. Place the HDD in accordance with

the four holes in the bottom.

6. Connect the HDD cable and

power cable.

Table of Contents