Table of Contents
Advertisement
6. Test all smoke detectors, following the manufacturer's instructions. The
identification of each detector should appear on the display when each is activated.
If a problem is experienced with any protection point (no confirming sounds, no
display), call for service immediately.
When all protection points have been checked and are intact (closed), there should
be no zone identification numbers displayed on the touchpad.
7. Exit test mode:
If the test mode is inadvertently left active, it automatically turns off after 4 hours.
During the final 5 minutes (after 3 hours 55 minutes of Test mode), the keypad emits a
double-beep every 30 seconds to alert that the end of Test mode is nearing.
– 40 –
+
(Security Code)
[ 1 ]
Hide quick links:
Advertisement
Table of Contents
