Arming Commands - ADT SASW3000EN User Manual

Before arming, close all perimeter doors and windows and make sure the Ready to Arm
message is displayed.
Modes of Arming
Mode
Stay
Night-Stay
Instant
Away
Quick Arming
If "Quick Arming" was programmed by the installer, the
place of the security code when arming the system in any of its arming modes.
However, the security code must always be used to disarm the system.
Function Key Arming
For any arming command, a function key may have also been programmed for your system. If
so, you can press and hold the appropriate function key for 2 seconds to arm the system. See
your installer for the designated functions (see Single Button Arming section).
Refer to the Accessing Other Partitions section for information on multi-partiion
arming.
– 16 –
Press these keys...
security code + [3] (STAY)
security code + [3] + [3]
security code + [7] (INSTANT)
security code + [2] (AWAY)
Touchpad Confirms By...
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
• three beeps
• NIGHT-STAY message displayed
• red ARMED indicator lights
• three beeps
• armed STAY message displayed
• red ARMED indicator lights
• also note that entry delay is turned off
• two beeps, or, if programmed, beeping
for duration of exit delay
• armed AWAY message displayed
• red ARMED indicator lights
Leave the premises through an entry/exit
door during the exit delay period to avoid
causing an alarm. The touchpad beeps
rapidly during the last 5 seconds of the
exit delay to warn you that it is ending.
key can be pressed in
[#]