ADT SASW3000EN User Manual page 25

The "A", "B", "C" or "D" keys can be used to automatically activate a series of
commands of up to 16 keystrokes, if programmed for this function. These keystrokes,
as a group, are called "macros" and are stored in the system's memory.
• Typical macro functions can include:
- Arming sequences: STAY, Night-STAY, INSTANT, or AWAY
- Bypassing particular zone(s)
- Activating relay(s) for turning on (or off) lights, fans, etc.
• Up to four macros can be assigned – but no more than one macro to a key.
• Macros can be activated only by users with authority levels authorized to
perform the macro's function.
NOTE: The installer must activate the desired function key (using *57 Function key
Menu Mode) before macros can be assigned.
See the chart at the back of this manual for the key(s) assigned for macros.
+ [#] + [6] + [6]
1.
(Security Code)
2. Enter the macro number, 1-4, to be programmed at
the "Select Macro?" prompt. Remember, there are
four macros available, but only one macro can be
assigned to each key.
3. If a macro has been previously defined, the
keystrokes are shown on the bottom line of the
display, otherwise the display is blank.
To exit this mode (and keep the existing macro
definition), press any key except the [∗] key. The
system returns to normal mode.
To define a macro for the selected key, press [∗] and
continue with the next prompt.
Enter the first of the series of desired commands, (do
not include your user code when programming a
macro), then press/hold the "D" key for at least two
seconds to complete the first command. This key
terminates each separate command, and appears as
an "F" in the touchpad display.
(-7%61)(
6)%(= 83 %61
7)0)'8 1%'63
 
1%'63 (-740%=
1%'63 4+1
– 25 –