ADT SASW3000EN User Manual page 19

The OFF key is used to disarm the system, silence alarm and trouble sounds, and
clear alarm memories.
IMPORTANT: If you return and the main burglary sounder is on, DO NOT ENTER, but
CONTACT THE POLICE from a nearby safe location.
If you return after an alarm has occurred and the main sounder has shut itself off, the touchpad
will beep rapidly upon your entering, indicating that an alarm has occurred during your
absence.
LEAVE AT ONCE, and CONTACT THE POLICE from a nearby safe location.
1. +
(Security Code)
The "READY" indicator light will be lit if all zones
are secure, and the touchpad will emit a single tone
to confirm that the system is disarmed.
NOTE: If entry delay has started (you've opened the
entry door), you do not need to press the OFF key;
simply enter your security code.
2. To Silence a Burglary Alarm and Clear a Memory of Alarm
Enter your security code. This disarms the system and silences the alarm (or
warning tones of a Memory of Alarm).
Note the zone in alarm on the touchpad display, and make that zone intact (close
door, window, etc.). Now enter the security code plus OFF sequence again to clear
the touchpad's Memory of Alarm display.
3. To Silence a Fire Alarm and Clear Memory of Alarm
Simply press the OFF key to silence the alarm. Note the zone in alarm on the
touchpad display, and check the detector. Now enter the security code plus OFF
sequence to clear the touchpad's Memory of Alarm display. See the Fire Alarm
System section.
1
OFF
(-7%61)(
6)%(= 83 %61
English Display: READY
– 19 –