Questions And Answers - Gigaset E310H Manual

Questions and answers

If you have any questions about
using your phone, visit us anytime at
www.gigaset.com/service.
In addition, the following table pro-
vides troubleshooting assistance.
The display is blank.
1. The handset is not activated.
¤ Press and hold the end call key
a.
2. The battery is empty.
¤ Charge the battery or replace it
(¢ page 11).
"Base" flashes in the display.
1. The handset is outside the range
of the base.
¤ Reduce the distance between
the handset and the base.
2. The range of the base is reduced
because Eco Mode mode is acti-
vated.
¤ Deactivate Eco Mode or reduce
the distance between the
handset and the base.
3. The base is not activated.
¤ Check the base power adapter.
"Put into base" or "Register HS"
flashes in the display.
The handset has not been regis-
tered with the base or has been de-
registered.
¤ Place the handset in the base
(automatic registration, may take
up to 5 minutes) or register the
handset manually (¢ page 13).
The handset does not ring.
The ringer is switched off.
¤ Activate the ringer (¢ page 39).
You cannot hear a ringtone/dial-
ling tone from the fixed line.
The phone cord supplied has not
been used or has been replaced by a
new cord with the wrong pin con-
nections.
¤ Please always use the phone cord
supplied or ensure that the pin
connections are correct when
purchasing from a retailer.
The connection always terminates
after approx. 30 seconds.
Repeater activated/deactivated.
¤ Activate/deactivate the handset
(¢ page 20).
When you try to activate Eco
Mode+, "Not possible!" appears in
the display.
A handset is registered to the base
that does not support Eco Mode+.
Error tone sounds after system PIN
prompt.
You have entered the wrong system
PIN.
¤ Reset the system PIN to 0000.
Forgotten system PIN.
¤ Reset the system PIN to 0000.
The number of the caller is not dis-
played although CLIP has been set.
Calling Line Identification is not ena-
bled.
¤ The caller should ask the network
provider to enable Calling Line
Identification (CLI).
Refer to the notes on Calling Line
Identification ¢ page 27.
43