HP EliteOne 800 G1 Maintenance & Service Manual page 98

To remove the system board:
1.
Prepare the computer for disassembly (see
2.
Remove the stand (see
3.
Remove the access panel (see
4.
Remove the lower rear panel (see
5.
Remove the VESA mounting plate (see
6.
Remove the memory modules (see
7.
Remove the graphics heat sink (see
8.
Remove the processor heat sink (see
9.
Remove the processor (see
10.
Remove the graphics board (see
11.
Remove the WLAN module (see
12.
Disconnect all cables from the system board, noting their location for reinstallation.
88 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis
Preparing to disassemble the computer on page
Stand on page 36).
Access panel on page
Lower rear panel on page
VESA mounting plate on page
Memory on page
Graphics heat sink on page
Processor heat sink on page
Processor on page
Graphics board on page
WLAN module on page
40).
73).
83).
51).
62).
63).
65).
66).
56).
34).