Adjustment Instructions; Chain Adjustment - Stamina 15-0960 Owner's Manual

ADJUSTMENT INSTRUCTIONS

Chain Adjustment

Chain Adjustment required if the Chain is too loose.
1. Loosen the NUTS(3/8"-26)(66) on both sides of the fan.
2. Adjust the NUT(M6x1)(65) on the chain side of bike to remove
all slack from the chain.
3. Adjust the NUT(M6x1)(65) on the side opposite the chain so
that the center of the NUT(3/8"-26)(66) is the same distance
from TAB on both sides of bike.
4. Tighten the NUTS(3/8"-26)(66) on both sides of the fan.
Fan Adjustment
Fan Adjustment is required if the fan locks up or the resistance of the fan increases after use. To
adjust the fan, use the following procedures:
STEP 1: Remove both PEDALS(31, 32).
STEP 2: Remove the SCREWS(52, 54, and 55) holding the CHAIN GUARDS(29, 30) and FAN CAGES(28)
to the BIKE. Remove the CHAIN GUARDS(29, 30).
NOTE: The CRANK(10) should be pointing down.
STEP 3: Remove the NUTS(3/8"-26)(66), EYE BOLTS(22), and NUT(M6x1)(65) from the FAN AXLE(21).
STEP 4: Slide the FAN(18) toward the rear and slide the CHAIN(17) off of the big sprocket on the
CRANK(10). Then slide the CHAIN(17) off of the small sprocket on the FAN(18).
STEP 5: Unhook the TENSION STRAP(25) from the FRAME(1). Remove the FAN(18) and FAN CAGES
(28) from the bike.
It is best to lift the front of the frame and remove the fan and fan cages thru the bottom of
HINT :
the bike.
Small Sprocket
15
TAB
Left Side View