Dimplex DF3015 Owner's Manual page 16

Maintenance
ness.
11. Install the Log Set Assembly
by placing the front, bottom
edge of the Ember Bed in the
track behind the control panel.
Once in place, push down on
the back edge of the Ember
Bed until the rear tab snaps
into place under the Mirror
(Figure 7).
!
NOTE: Ensure the Log Set
Assembly is installed tightly
under the back ledge to pre-
vent light leakage.
12. Slide front glass back into
position and attach trim.
Upper Light Bulb Requirements
Quantity of two (2) clear chande-
lier or candelabra bulbs with an
E-12 (small) socket base, 15 Watt
rating. Do not exceed 15 Watts
per bulb.
To access the upper light bulb
area:
CAUTION: Allow at least five
minutes for light bulbs to cool off
before touching bulbs to avoid ac-
cidental burning of skin.
1. Slide fireplace out of mantel.
2. Remove four Phillips screws
from right side of trim (Figure
6).
16
Figure 7
Back
Ledge
Rear
Tab
Side Section
3. Remove trim.
4. Slide glass to the right side of
the fireplace to remove (Figure
6).
5. Remove Upper Light Bracket
(Figure 6).
6. Upper bulbs are located in
the upper left and upper right
corners of the fireplace.
7. Unscrew bulbs counter clock-
wise.
8. Insert new bulbs and screw in
clockwise.
9. Re-install Upper Light Bracket.
10. Slide front glass back into
position and attach trim.
Purifire™ Filter
The Purifire™ filter supplied in
your fireplace is reusable and
washable. The filter should be
cleaned or replaced on average
Log
Ember Bed
Front
Edge
www.dimplex.com