ResMed S8 Escape II Auto User Manual page 8

You can set the ramp/settle time in 5-minute intervals, from 0 minutes (OFF) up
to a maximum time set by your clinician.
The current ramp or settling time is displayed in the right corner of the standby
screen.
1
Press
2 Once a ramp or settling time is selected, begin therapy by pressing
When ramping or settling begins the LCD will display the word "RAMPING or
APAP" depending on the mode, with the current pressure indicated as dashes.
Each dash is approximately equivalent to 2 cm H
represents approximately 12 cm H
How to change the EPR level
EPR can be used to help ease any discomfort you may experience when
breathing out during treatment. If your clinician has allowed access you can
change the EPR level. There are four settings: OFF; 1 (lowest EPR); 2; and 3
(highest EPR).
1
On the standby (RAMP/SETTLE) screen, press
2
Press
3
Press
4
Press
How to change the language setting
1
On the standby (RAMP/SETTLE) screen, press
2
Press
3 Press
4 Press
Messages on the S8 Escape II Auto LCD
Your clinician may have set your S8 Escape II Auto to remind you about important
events, such as when to replace your mask, when to insert your Data Card (if
your device is Data Card enabled) and so on.
The reminder message is displayed on the LCD and is visible if the device is not
delivering therapy. The backlight on the LCD flashes when a message is
displayed.
6
or until the desired ramp or settling time appears.
until you see EPR LEVEL, then press
or until you see the setting that you require.
(Apply) to save the setting.
until you see LANG (Language), then press
or until you see the language that you require.
(Apply) to save the new language.
O. For example, six dashes
2
O pressure.
2
(Menu).
(Menu).
(Change).
(Change).
.