Vent System Identification - Empire Comfort Systems DVP42DP31N-2 Installation Instructions And Owner's Manual

Installing Vent Components (Figure 41)
Begin the vent system installation by installing the first Simpson
Duravent component, 90° elbow to the starting collars or straight
pipe on the top of the appliance, then the straight pipe length and
then horizontal or vertical termination kit.
NOTICE: All outer connection joints must be sealed with
aluminum tape, screws or silicone sealant rated above
300°F/149°C. The inner flue joints do not require any sealant.
28651-2-0811

VENT SYSTEM IDENTIFICATION

Figure 41
Simpson Duravent vent system components lock into place by sliding
the concentric pipe section with four (4) equally spaced interior beads
onto the appliance collar or previously installed component end with
four (4) equally spaced indented sections. When the internal beads
of each starting outer pipe line up, rotate pipe section clockwise 90°
(approximately 3 inches). The vent pipe is now locked together.
Continue adding components per the pre-planned vent system
configuration. Be certain that each succeeding vent component
is securely fitted and locked into the preceding component in the
vent system.
WALL THIMBLE
(MAXIMUM OF
TWO 90 ELBOWS)
Special DV Vent Kits
Available from Empire Comfort Systems, Inc. dealers.
DVVK-5RP Direct-Vent Fireplace Vent Kit for Rear Vent, 6 to 12 inch wall
(DVVK-5R) thickness, Includes 58DVA-06, 58DVA-WT, and 58DVAHC
Direct-Vent Fireplace Vent Kit for Top Vent, Thru-the-wall,
DVVK-5TP
4 to 6 inch wall thickness, Includes 58DVA-E90, 58DVA-HC,
(DVVK-5T)
58DVA-06, and 58DVA-WT
DVVK-5VP Direct Vent Fireplace Vent Kit - Vertical, Includes
(DVVK-5V) 58DVA-VCH, 58DVA-SC, and 58DVA-F6
Top Vent Kit (Horizontal) - 4½" to 6" wall thickness
DVVK-5TS
(114.3 mm to 152 mm)
DVVK-5F Horizontal Flex Vent Kit (4' Flex) (1.22m)
(MAXIMUM OF
THREE 90 ELBOWS)
Page 25