Setting Display Position - Samsung RD-840/1640 User Manual

using the DVR
Monitor
You can configure information to be displayed and its format for Spot Out monitor.
Setting the Monitor
Using the mouse may help make setup easier.
1. Use the up/down buttons ( ) in <Device> window to
move to <Monitor>, and press [ENTER] button.
2. Select <Monitor>.
3. Use direction buttons ( ◄ ►) to move to a desired
item, and set the value.
• Event Display : Sets the dwell time of the event channel
display on the monitor when an event occurs.
If selected <Continuous>, it displays the channel until you
press [ALARM] button to release it.
• Display : Displays only checked items on the monitor screen.
• Multi CH SEQ Time : Sets the interval between automatic display switching in 4-split and 9-split mode of
the Live screen.
• Video Output : You can set the video output mode.
- Auto : The default is set to Composite. (In VGA mode, the "SAMSUNG" logo will be displayed)
The main video mode will switch to VGA if a VGA monitor is connected. Then, the Composite port will act
as SPOT source. The monitor distributor is not supported. To switch to VGA mode, turn off the DVR set
and connect the VGA jack. (The VGA monitor will turn on)
- VGA : The main video mode will switch to VGA after the DVR set reboots; the composite source will be
displayed on the spot screen.
- Composite : The main video mode will switch to Composite after the DVR set reboots. In VGA mode, the
"SAMSUNG" logo will be displayed.
4. When the monitor setup is done, press <OK>.

If you want to change the default output to VGA mode when the live screen is displayed with the beep after the system
booting, press the remote control buttons in sequence: [FREEZE]  [VIEW]  [RETURN (
[VIEW]  [RETURN (

Setting Display position

Some monitors many not display information (camera name, icon, time information, etc.) about the DVR,
depending on the condition. Then, you can change the display position of the data.
1. In the <Device> window, press the up/down ( ) button to move to <Monitor> and press the [ENTER]
button.
2. Select the <Monitor> item.
3. Select <Display Position Setup> in the bottom.
You will move to the <Display Position Setup> window.
4. Use the four direction buttons or the number buttons on
the remote control to adjust the data position.
44_ using the DVR
)]. The DVR will switch to VGA mode with the beep after rebooting.
Monitor
Monitor
Spot Out Mode
 Event Display
OFF
 Display
Date Time CH Name
 Multi CH SEQ Time
5 sec
 Video Output
Auto
Display Position Setup
OK Cancel
)]  [FREEZE] 
2012-01-01 01:10:25
Display Position Setup
30
30
30
OK Cancel
Icon
30