Updating The Software - Samsung RD-840/1640 User Manual

• Updating the Software

1. Connect a device storing the software to be updated.
(It may take about 10 seconds to recognize the device.)

Upgradeable devices include USB memory and network device.

To update the network, the current DVR should have been
connected to the network.
Upgrade via the proxy server may not be enabled due to the
restricted access.
2. Select <System Management> from <System> window.
3. Select <System Information>.
4. When the recognized device appears, select <Upgrade>.

The <Upgrade> button will be activated only if the current <Software Version> of the <System Information> is
same to or older than that of <S/W Upgrade>.
5. Press <OK> in the "System Upgrade" window.

While updating, it shows the progress.
• Updating progresses with 3 steps as shown in the figure.
6. When the updating is done, it automatically restarts.
Do not turn the power off until it finishes restarting.
M 
If "Upgrade Failed" appears, retry from the step 4.
When you experience continued failure, consult the service
center for assistance.

When you perform S/W update remotely using Smart Viewer,
it may take a max of 3 minutes to complete the update since
Smart Viewer popped up a confirmation message. This is to
guarantee that the DVR set operates stably. For a faster
update, use the USB cable to connect to the DVR set.
System Management
System Information
Settings
 System Information
 Software Version
v1.0xh_yymmddhhmmss
System Upgrade
 Broadcast Format
NTSC
 MAC Address
00:00:F0:54:FF:FF
Current Version v1.0xh_yymmddhhmmss
New Version v1.0xh_yymmddhhmmss
 S/W Upgrade
Do you want to upgrade?
 Device
USB2FlashStorage Upgrade
OK Cancel
 Version
V1.08_090731170402
Previous
System Management
System Information
Settings
 System Information
 Software Version
v1.0xh_yymmddhhmmss
 Broadcast Format
NTSC
S/W Upgrade
 MAC Address
00:00:F0:54:FF:FF
Software upgrading...
 S/W Upgrade
 Device
USB2FlashStorage Upgrade
 Version
V1.08_090731170402
Previous
System Management
System Information
Settings
 System Information
 Software Version
v1.0xh_yymmddhhmmss
 Broadcast Format
NTSC
S/W Upgrade S/W Upgrade
 MAC Address
00:00:F0:54:FF:FF
Software upgrading...
Software upgrading...
 S/W Upgrade
Do not turn off during the upgrade.
 Device
Upgrade
USB2FlashStorage
 Version
V1.08_090731170402
Previous
English _35