Setting Display Position - Samsung SRD-470 User Manual

using the DVR
monitor
You can configure information to be displayed and its format for Spot Out monitor.
Setting the monitor
Using the mouse may help make setup easier.
3. Use the up/down buttons (▲▼) in <device> window to
move to <monitor>, and press [enTer] button.
4. Select <monitor>.
5. Use direction buttons (▲▼_ +) to move to a desired
item, and set the value.
Event Display : Sets the dwell time of the event channel
~
display on the monitor when an event occurs.
If selected <Continuous>, it displays the channel until you
press [ALArm] button to release it.
~ Display : Displays only checked items on the monitor
screen.
VGA : The current monitor may not display the video if the <vgA> settings do not match with this player
~
Sharpness : You can adjust the sharpness of the video output signal.
~
6. When the monitor setup is done, press <oK>.

Setting Display position

Some monitors many not display information (camera name, icon, time information, etc.) about the DVR,
depending on the condition. Then, you can change the display position of the data.
3. In the <device> window, press the up/down (▲▼) button
to move to <monitor> and press the [enTer] button.
4. Select the <monitor> item.
Select <display position Setup> in the bottom.
5.
You will move to the <display position Setup> window.
6.
Use the four direction buttons or the number buttons on
the front panel or the remote control to adjust the data
position.
48_ using the DVR
Monitor
Monitor
Spot Out Mode
 Event Display OFF
 Display Date Time CH Name
 VGA 800x600
 Sharpness Level1 (Low)
Display Position Setup
OK Cancel
Display Position Setup
30
30
30
OK Cancel
Icon
30