Setting Display Position - Samsung SRD-442 User Manual

Setting Display position

Some monitors many not display information (camera name, icon, time information, etc.) about the DVR,
depending on the condition. Then, you can change the display position of the data.
1. In the <Device> window, press the up/down ( ) button to move to <Monitor> and press the [ENTER]
button.
2. Select the <Monitor> item.
3. Select <Display Position Setup> in the bottom.
You will move to the <Display Position Setup> window.
4. Use the four direction buttons or the number buttons on
the front panel or the remote control to adjust the data
position.
Setting the Spot Out
You can set the DVR to output information / video apart from the monitor out.
Using the mouse may help make setup easier.
1. Use the up/down buttons ( ) in <Device> window to
move to <Monitor>, and press [ENTER] button.
2. Select <Spot Out>.

The number of Spot Out terminals differs according to the
model.
3. Use direction buttons ( ◄ ►) to move to a desired
item, and set the value.
• Spot Out 1 : You can select between SEQ and Single.
• Set Mode : A window for "Set Spot Out" appears and you
can set the channel for it.
You can set the dwell time between the screen switching in
"Setting the Device > Camera > SEQ-Dwell Time".
(Page 41)
• Event Display : Specify the time to display on the spot
output of the channel where an event took place.
If selected <Continuous>, it displays the channel until you
press [ALARM] button to release it.
M 
You can setup using the mouse right button in Live screen.
Refer to "Spot Out". (Page 27)
4. When the Spot Out is done, press <OK>.
2012-01-01 01:10:25
Display Position Setup
30
30 30
30
OK Cancel
Monitor
Spot Out
Monitor Mode
 Spot Out 1 Set Mode
SEQ
 Event Display
OFF
OK Cancel
Monitor
Spot Out
Monitor Mode
 Spot Out 1
SEQ Set Mode
Set Spot Out
1 2 3
 Event Display
OFF
OK
OK Cancel
English _49
All
All
4