Table of Contents
Advertisement
ITEM
JAM RECOVERY
ERROR REPORT
PCL
EMULATION
This menu controls the printer's PCL emulation.
ITEM
FONT SOURCE
FONT NO.
FONT PITCH
FONT HEIGHT
SYMBOL SET
A4 PRINT WIDTH
WHITE PAGE SKIP
CR FUNCTION
LF FUNCTION
PRINT MARGIN
PEN WIDTH ADJUST
DEFAULT
ON
OFF
DEFAULT
RESIDENT
I0
10.00CPI
12.00POINT
PC-8
78 COLUMN
OFF
CR
LF
NORMAL
ON
Menu functions > 21
REMARKS
Specifies whether the printer should perform jam
recovery after a paper jam has occurred. If ON, the
printer will attempt to re-print any pages lost due to a
paper jam once the jam has been cleared.
If ON, the printer will print error details when a
PostScript Emulation error occurs.
Note: Applies to PS & PCL XL only.
REMARKS
Specifies the location of the PCL default font.
Normally this will be INTERNAL unless additional
fonts are installed in the expansion ROM slot or
additional fonts have been downloaded to RAM as
permanent fonts.
Sets the current default font number from the
currently selected source.
Sets the width of the PCL default font in characters/
inch (CPI).
Default font is the fixed-pitch, scalable font. The
value is displayed to the second decimal place
Displayed only when the font selected in Font No. is
fixed-spacing, scalable font.
Height of the PCL default font.
Note: This menu item is displayed only when the font
selected in Font No. is a proportional-spacing,
scalable font.
PCL symbol set. If the font source and number are
changed to one which does not support the selected
symbol set, this must be changed to an available
symbol set for that font.
Sets the number of columns subject to Auto LF with
A4 paper in PCL. This is the value when Auto CR/LF
Mode is set to OFF with the 10CPI character.
Selects whether blank pages are printed or not.
Selects whether a received carriage return character
(0Dh) also causes a line feed.
Selects whether a received line feed character (0Ah)
also causes a carriage return.
Sets the non-printable page area. NORMAL is PCL
compatible.
When minimum width is specified in PCL, sometimes
a 1-dot line, looks broken.
With PEN WIDTH Adjust set to ON, when the
minimum width is specified, the line width will be
emphasized so as to look wider than a 1-dot line.
With PEN WIDTH Adjust set to OFF, the line will
appear as before.
Advertisement
Table of Contents
