5.2c FOUr-WaY iNTercOM
To set up four-way intercom conference mode proceed as
follows:
In this configuration the two passengers (numbered 2 and 4) are
each using two Bluetooth connections:
Passenger 2 is paired to rider 1 and to Passenger 4
Passenger 4 is paired to rider 3 and to Passenger 2
PairiNG FOUr scala rider G9 UNiTs
1. P air rider 1 to Passenger 2 using Channel "A" (see section 5.2a).
2. P air rider 3 to Passenger 4 using Channel "A" (see section 5.2a).
3. P air Passenger 2 to Passenger 4 using Channel "B" (see
section 5.2a).
The Four-Way Pairing is complete and ready to use.
iMPOrTaNT: Four-Way conference Mode considerations
During a 4-Way Intercom call, the two passengers who maintain two
active connections simultaneously will not be able to receive mobile
phone calls or GPS instructions as long as the conference call is in
progress.
|
|
scala rider
scala rider
G9 / G9 PowerSet
G9 / G9 PowerSet
®
®
16
16
5.3 CLICK-TO-LINK iNTercOM MOde
Click-to-Link is a spontaneous, "social" feature of your G9.
Use Click-to-Link to instantly initiate 1-on-1 intercom calls
with other scala rider users near you, without those users
already being paired to you. Think of it as a private Bike-to-Bike
channel that you can set up on-the-go with other scala rider G9 or
G4 users that you see along the way.
The Click-to-Link feature can be disabled on your G9 effectively blocking
any attempt by a third party to send a Click-to-Link request to you.
eNaBle/disaBle CLICK-TO-LINK
The feature can be turned on or off via the Voice Menu (see
Section 4.7)
NOTe: By default, Click-to-Link is DISABLED.