Maintenance - Dovre SAPPHIRE DV425TR Owner's Manual And Installation Instructions

DV425TR DIRECT VENT ROOM HEATER
Installation and repair should be done only by a qualified service person. The appliance should be inspected
before use and at least annually by a professional service person. More frequent cleaning may be required due
to excessive lint from carpeting, bedding material, pet hair, et cetera. It is imperative that control compartments,
burners and circulating air passageways of the appliance be kept clean. Note: If venting is disconnected for any
reason, the vent-air intake system must be properly resealed and reinstalled.
WARNING! DO NOT CLEAN GLASS WHEN HOT! TURN UNIT OFF AND ALLOW TO COOL. DO NOT
USE ABRASIVE or CHEMICAL CLEANERS ON GLASS SURFACE! DO NOT OPERATE
WITH THE GLASS FRONT REMOVED CRACKED OR BROKEN! DO NOT STRIKE OR SLAM
THE DOOR!
___Turn off pilot light.
___Open door by releasing two spring latches at the top of appliance door beneath the top, and lift door up.
___Using glass cleaner, wipe with soft cloth or clean paper towel until surface is dry.
___Relight pilot.
___Re-attach door.
___Check burner operation.
NOTE: If you observe a white film on the door glass, use a hard water deposit glass cleaner or contact your
dealer. The use of a glass cleaner will reduce the mineral deposits.
WARNING! You must clean all the fingerprints and oils from gold surfaces prior to firing the stove
for the first time. Use a glass cleaner or vinegar and a very soft towel to remove the oils. If gold is not
cleaned properly prior to lighting the first fire, the oils remaining from fingerprints can cause permanent
staining on the gold plating. After the plating is cured, the oils will not affect the finish and regular
maintenance can be provided using glass cleaner and a very soft cloth as needed.
02/01

MAINTENANCE

GLASS CLEANING
GOLD - CARE AND TREATMENT
Page 51 250-5533