Table of Contents
Advertisement
DV425TR DIRECT VENT ROOM HEATER
WARNING: If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
A. This appliance has a pilot that must be lit manually. When lighting the pilot, follow these instructions exactly
B. BEFORE LIGHTING, smell around the appliance area for gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explo-
sion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system and any gas control which has been under water.
1.
STOP! Read the safety information above on this label.
2.
Set the thermostat to the lowest setting (if applicable) and turn off the
switch at the control panel.
3.
Disconnect power from appliance.
4.
Remove face and open the door of the appliance.
5.
Wait five (5) minutes to clear out any gas. Smell for gas, including near the floor. If you smell gas, STOP! Follow "B" of
the safety information above. If you don't smell gas go to the next step.
6.
Push gas control knob in and turn counter-clockwise
knob is pushed in slightly. Do not force.
7.
Press down on the gas control knob in pilot position and simultaneously press piezo igniter. (This may take many
repetitions for lighting.)
8.
The pilot should be visible through the door below the top log.
9.
After the pilot is lit, continue holding control knob down for approximately 30 seconds. Release knob and it will pop
back up. Pilot should remain lit. If it goes out, repeat steps 6 through 8.
•
If the knob does not pop up when released, stop and immediately call your service technician or gas supplier.
•
If the pilot will not stay lit after several tries, turn the gas control knob clockwise
service technician or gas supplier.
10. Push down and turn gas control knob counter-clockwise
11. Turn burner switch on the control panel to "ON". If thermostat is to be used,
leave switch in "OFF" position and set the thermostat to desired setting.
12. Re-install door and face.
13. Reconnect electrical power to appliance.
1.
Set the thermostat to lowest setting.
2.
Push in gas control knob slightly and turn clockwise
Do not force.
02/01
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
to pilot position. NOTE: Knob cannot be turned unless
to "ON".
Millivolt
Generator
to "OFF" position.
Page 47
to "OFF" and call your
Pilot Hood
Thermocouple
250-5533
Hide quick links:
Advertisement
Table of Contents
