Acura 2004 MDX Owner's Manual page 130

Main Menu
Table of Contents
Playing a Tape
To Play a Tape
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Make sure the open side of the tape
is facing right, then insert the tape
most of the way into the slot. The
system will pull the tape in the rest
of the way, and begin to play it.
The tape direction indicator in the
display comes on to show you which
side of the tape is playing. The
indicates the side you inserted
upward is now playing. If you want to
play the other side, press the PROG
button. When the player reaches the
end of the tape, it will automatically
reverse direction and play the other
side.
126
Comfort and Convenience Features
Dolby noise reduction turns on
when you insert a tape. The
indicator will come on in the
display. If the tape was not recorded
in Dolby, turn it off by pressing the
button. Dolby remains off until
you press the button again.
Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing Corpo-
ration. ''DOLBY'' and the double-D symbol
are trademarks of Dolby Laboratories
Licensing Corporation.
To Stop Playing a Tape
To remove the tape, press the tape
EJECT button. If you want to turn
the player off, press the PWR/VOL
knob or turn off the ignition. The
tape will remain in the drive. When
you turn the system back on, the
tape will begin playing where it left
off.
To switch to the radio while a tape is
playing, press the AM or FM button.
To change back to the tape player,
press the TAPE button.
Tape Search Function
To rewind the tape,
FF/REW
push the REW ( ) button. You
will see REW in the display. To fast
forward the tape, push the FF
( ) button. You will see FF
displayed. Press the PLAY/PROG
button to take the system out of
rewind or fast forward.