Removing The Ssd Drives From The Nim-Ssd - Cisco 4451-X Hardware Installation Manual

Chapter 6 Installing and Upgrading Internal Modules and FRUs
Figure 6-9
1. Carrier card slot cover
Insert an SSD in the lower slot first.
Step 3
Step 4 The SSD should be inserted connector end first with the connector side down and serial number facing
up (Figure
A second SSD may be inserted in the upper slot as shown in
Step 5
Rotate the SSD card slot cover up and into place over the SSD's.
Step 6
Step 7 Re-tighten the captive fasteners on the SSD card slot cover.

Removing the SSD Drives from the NIM-SSD

To remove the SSD cards from the NIM carrier, follow these steps:
On the NIM-SSD, loosen the captive screws retaining the NIM-SSD slot cover.
Step 1
Rotate the SSD card slot cover down, exposing the slots which hold the SSDs.
Step 2
To remove the SSD one at a time, pull the two tabs on the front of each SSD as shown in
Step 3
Rotate the SSD card slot cover up and into place over the SSDs.
Step 4
Re-tighten the captive fasteners on the SSD card slot cover.
Step 5
OL-27644-01
Opening the SSD slot cover
6-6).
Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
Overview of the SSD Carrier Card NIM (NIM-SSD)
1
Figure 6-7.
Figure 6-10.
6-13