Software Requirement For Sms; Locating An Sm Or Nim; Removing An Sm Or Nim; Installing An Sm - Cisco 4451-X Hardware Installation Manual

Chapter 6 Installing and Upgrading Internal Modules and FRUs

Software Requirement for SMs

Cisco IOS XE software of a specified release or later release is required for using an SM.
To determine the version of Cisco IOS software that is running on your router, log in to the router and
enter the show version command:
Router> show version
Cisco Internetwork Operating System Software
4400 Software (C4400-ADVENTERPRISEK9-M), Version 12.3(8.2)T, INTERIM SOFTWARE

Locating an SM or NIM

See the
slot on the motherboard.

Removing an SM or NIM

Use the following procedure to remove an SM:
Read the
Step 1
any module replacement.
Access the SM slot. See
Step 2
Loosen the captive screws to open the slot cover. See
Step 3
Pull the SM out of the connector on the motherboard. Keep the SM parallel with the motherboard to
Step 4
prevent damage to the slot and standoff.
Place the SM in an antistatic bag to protect it from ESD damage.
Step 5

Installing an SM

To install an SM, use a number 2 Phillips screwdriver or flat-blade screw drive, and a 1/4-inch nut driver
or wrench.
Read the
Step 1
any module replacement.
Identify the SM slot you will insert the SM into.
Step 2
Loosen the captive screws to open the slot cover. See
Step 3
Insert the SM to the system board.
Step 4
Note
Insert the screws from the accessory kit through the SM into the standoffs. See
Step 5
tighten the screws with a Phillips screwdriver (torque 6 to 8 in-lb or 0.7 to 1.1 Nm.).
OL-27644-01
"Locating Internal and External Slots for Modules" section on page 6-5
"Safety Warnings" section on page 6-2
Figure 6-2
"Safety Warnings" section on page 6-2
Be sure to press firmly on the SM until the board seats onto the connector.
Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
and disconnect the power supply before you perform
for the various NIM and SM slot locations.
Figure 6-8
and disconnect the power supply before you perform
Figure 6-8
Installing and Removing NIMs and SMs
to locate the SM or NIM
and Figure 6-9.
and Figure 6-9.
Figure 6-20. Carefully
6-24