Section 8 - Batteries; Using The Proper Batteries - Invacare Xterra GT Operating And Maintenance Manual

Power wheelchair
Hide thumbs Also See for Xterra GT:
Table of Contents

Advertisement

SECTION 8
This SECTION Includes the Following:

Using the Proper Batteries

Installing/Removing Batteries
Disconnecting Battery Cables
Connecting Battery Cables
Make sure power to the wheelchair is OFF before performing this
SECTION.
The use of rubber gloves and chemical goggles is recommended when
working with batteries.
Invacare strongly recommends that battery installation and battery
replacement always be done by a qualified technician.
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may result.
This SECTION MUST be performed while the wheelchair is unoccupied.
USING THE PROPER BATTERIES (FIGURE 1)
1. Place battery on ground/flat surface.
2. Visually draw a horizontal and vertical centerline through the middle of battery.
3. Position the battery so that the terminals are above the horizontal centerline.
4. Visually inspect the battery to ensure the following:
A. The POSITIVE battery terminal/post is located in the upper left corner.
B. The NEGATIVE battery terminal/post is located in the upper right corner.
Batteries with terminal configuration (positive on the left and negative on the
right) as shown below MUST be used. Batteries that have the reverse terminal
configuration MUST not be used - otherwise injury and damage may occur.
PROPER BATTERY TO BE USED
POSITIVE (+) Battery
Terminal/Post
Centerline
FIGURE 1 - USING THE PROPER BATTERIES
Xterra™GT™
WARNING
WARNING
NEGATIVE (-) Battery
Terminal/Post
Centerline
42
When to Charge Batteries
Charging Batteries
Replacing Batteries
NEGATIVE (-) Battery
Terminal/Post
POSITIVE (+) Battery
Terminal/Post
Part No. 1106627
BATTERIES

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents