Section 6 - Positioning Strap; Replacing Seat Positioning Strap - Invacare Xterra GT Operating And Maintenance Manual

SECTION 6
This SECTION Includes the Following:

Replacing Seat Positioning Strap

After ANY adjustments, repair or service and BEFORE use, make sure
that all attaching hardware is tightened securely - otherwise injury or
damage may result.
REPLACING SEAT POSITIONING STRAP (FIGURE 1)
STANDARD/ADJUSTABLE SEAT FRAMES
1. Remove the seat cushion from the seat
pan.
2. Move the flip back armrests out of the
way. Refer to USING/ADJUSTING FLIP
BACK ARMRESTS in SECTION 5 of
this manual.
3. Remove the two (2) mounting screws,
quick release pin tabs, spacers, and
locknuts that secure the seat pan and
seat positioning straps to the seat frame.
4. Remove the two (2) halves of the seat
positioning strap from the rear seat
frame.
NOTE: Quick release pin tabs are positioned
underneath the seat positioning strap.
5. Reposition the two (2) NEW seat
positioning strap halves underneath seat
rails.
6. Reinstall the two (2) mounting screws,
quick release pin tabs, spacers, and
locknuts that secure the seat pan and
seat positioning straps to the seat frame and torque to 75-inch pounds.
7. Reinstall the seat cushion onto the seat pan.
Xterra™GT™
WARNING
Mounting
Screw
Seat
Positioning
Strap
Rear of
Seat Frame
Quick
Release Pin
Tab
Seat Rail
FIGURE 1 - REPLACING SEAT
POSITIONING STRAP
40
POSITIONING STRAP
Seat Pan
Front of
Seat Frame
Spacer
Locknut
Part No. 1106627