Removing an Expansion SDRAM Module
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. From the bottom of the computer, remove the screw from the SDRAM cover, and remove the cover.
3. Release the latches at the sides of the SDRAM module (so that the module's free edge pops up),
then pull the module out of the connector.
Reassembly Note
Carefully insert the edge of the new SDRAM module into the connector at about a 30° angle until
it is fully seated. Then press down on both sides of the module until the latches snap closed.
HP Omnibook 500
Figure 2-10. Removing an SDRAM Expansion Module
Screw, M2×3mm
Removal and Replacement
2-13