HP DesignJet 500 Service Manual page 95

System Devices Menu
PS/2 Pointing Devices
External Fn Key
FDD controller
Legacy USB Support
Serial Port
Base I/O address
Infrared port
Mode
Base I/O address
DMA channel
Parallel Port
Mode
Base I/O address
DMA channel
Security Menu
User Password is
Administrator Password is
Set User Password
Set Administrator
Password
Password required to:
Boot
Resume*
Undock*
Internal hard disk drive
lock*
Removable Device Boot
* Available only if the Boot option is enabled.
HP Omnibook 500
Automatically disables the internal pointing devices when an
external PS/2 mouse is connected.
Sets whether left CTRL+left ALT on an external PS/2
keyboard is interpreted as the Fn key.
Enables the floppy drive.
Enables BIOS support for USB mouse, keyboard, and floppy
disk drive.
Enables the serial port (the port is configured by the user).
Sets the I/O address and interrupt (appears only if the serial
port is Enabled).
Enables the infrared port (the port is configured by the user).
Sets the port to FIR (fast IR) or SIR (standard IR) infrared
communications.
Sets the I/O address and interrupt.
Sets the DMA channel for the infrared port in FIR mode.
Enables the parallel port (the port is configured by the user).
Sets the port to output only, bi-directional, EPP, or ECP.
Sets the I/O address and interrupt.
Sets the DMA channel for ECP mode (appears only if the
Parallel Port Mode is ECP).
Shows if a user password is set.
Shows if an administrator password is set.
Press ENTER to set, change, or clear the user password. The
password can have no more than 8 characters (0–9,
A–Z), and cannot include special or accented characters.
Press ENTER to set, change, or clear the administrator
password, which protects BIOS Setup settings. The password
can have no more than 8 characters (0–9, A–Z), and cannot
include special or accented characters.
Sets whether a user password is required when the computer
boots. Requires the administrator password for changes.
Sets whether a user password is required when resuming
from Standby or Hibernate mode. Requires the administrator
password for changes. (Windows 98 only.)
Sets whether a user password is required when undocking the
computer. Requires the administrator password for changes.
(Windows 98 only.)
Encodes the current user password (or administrator
password if that is the only password set) on the hard disk.
Sets whether the computer will attempt to boot from a floppy
drive or other removable device.
Troubleshooting and Diagnostics
Default
Auto
Enabled
Enabled
Enabled
Enabled
3F8h, IRQ4
Disabled
FIR
2F8h, IRQ3
DMA1
Enabled
ECP
378h, IRQ7
DMA0
Default
Clear
Clear
Enter
Enter
Enabled
Enabled
Disabled
Disabled
Enabled
3-33