HP DesignJet 500 Service Manual page 96

Power (APM) Menu
Intel SpeedStep Mode*
Power Management Mode
Smart CPU Mode
Suspend Time-out
Hibernate Time-out**
Hard Disk Time-out
Time-out on AC
Lid Switch Mode
Resume On Serial Ring
Resume On Time of Day
Resume Time
Auto Suspend on Undock*
Auto Turn-On on Dock*
* Windows 98 and 2000 use these settings.
** Windows 98 uses this additional setting.
Boot Menu
+Hard Disk
+Removable Device
CD-ROM/DVD Drive
Internal NIC
Exit Menu
Save Changes and Exit
Discard Changes and Exit
Get Default Values
Load Previous Values
Save Changes
3-34 Troubleshooting and Diagnostics
Sets the speed used by a dual-speed processor at boot,
depending on the available power source. A separate Control
Panel power setting controls speed changes after boot.
Disables time-outs, selects a pre-set combination of time-outs,
or allows customized time-outs.
Enables automatic CPU power savings when running on
battery power. Absence of keyboard, mouse, and hard disk
activity could slow CPU response.
Sets the period of inactivity after which the computer goes
from full-power mode to Standby power mode.
Sets the period of inactivity after which the computer goes
from full-power mode or Standby mode to Hibernate mode.
(Skips Standby mode if the Suspend Time-out is disabled.)
Sets the period of hard disk inactivity after which the internal
hard disk (and any hard disk in a plug-in module bay) stops
spinning.
Sets whether power management time-outs occur while the
AC adapter is connected.
Sets the action that occurs if the computer's lid is closed.
Sets whether the system resumes if it receives a ring signal.
Sets whether the system resumes at a defined time of day.
Sets the 24-hour time when the system resumes if Resume
On Time of Day is enabled.
Sets whether the computer suspends to Standby mode after
undocking.
Sets whether the computer turns on after docking.
Shows the order of boot devices, with "+" indicating a device
category. Move the entries to change the order. If the
computer has more than one device in a category, you can
select the one scanned. Internal NIC (Network Interface Card)
appears in the list only if a built-in LAN is present—it provides
diskless boot from a network server.
Saves Setup changes, then exits and reboots.
Discards any Setup changes made since last save, then exits
and reboots. Does not affect password, date, or time changes.
Restores default settings, and remains in Setup. Does not
affect password, date, or time changes.
Discards any Setup changes made since last save, and
remains in Setup. Does not affect password, date, or time
changes.
Saves Setup changes, and remains in Setup. Security
settings are saved when changed.
Default
Auto
Max. Power
Savings
On
4 minutes
4 hours
2 minutes
Disabled
Turn off LCD
Disabled
Disabled
When Lid Closed
Enabled
Default
1. Hard Disk
2. Removable
Device
3. CD-ROM/DVD
drive
4. Internal NIC
HP Omnibook 500